Black Widow Security BW RAS 130 Instrukcja Instalacji Pobierz pdf (Strona 2)

2

Before you begin the installation:

• Verify that the vehicle is equipped with

electronic fuel injection.

• Verify that the vehicle is equipped with an

automatic transmission.

• Check to see if the vehicle is equipped with

any type of factory security system.

• Check to see if there is a pin switch for the

hood, if not one must be installed.

• Verify that the vehicle starts and idles prop-

erly before you start the installation.

• Verify with the customer the desired location

for the program switch and LED.

• Always use a multi-meter when verifying

vehicle wiring.

Remote Start Installation Notes:

The system senses the vehicle’s successful start

using one of the following methods:

1. Current sense

2. Tachometer sense

3. Spark or Coil Wire sense

4. Using optional vacuum switch.

If the Current Sense feature does not allow

proper operation, the tachometer sense/spark

sense wire may be used, or an optional vacuum

switch can be installed.

To use the tach sense/spark sense wire, set dip

switch #4 to the

off position. Connect the gray

wire directly to the vehicle’s tach wire or extend

it into the engine compartment and wrap it

several times around a spark plug or coil wire.

In situations were a tach wire is unavailable or

does not allow proper operation,an optional vac-

uum switch can be installed. The vacuum switch

is designed to be placed in line with one of the

vehicle’s vacuum hoses and provide a ground out-

put (N/C) until the engine is started. To use the

vacuum switch, set dip switch #2 to the

off posi-

tion. Connect the yellow wire (3-pin red con-

nector) to one terminal of the vacuum switch

and connect the other terminal to ground.

High-Current Wire Connections:

• RED WIRE #1 -Main power input; using the

supplied inline fuse holder, connect directly to

the vehicle’s battery or alternate power source

with a minimum 30 Amp supply.

• RED WIRE #2 - Secondary power input; using

the supplied inline fuse holder, connect directly

to the vehicle’s battery or alternate power

source with a minimum 30 Amp supply.

Note: If not connecting directly to the vehicle’s

battery, it is recommended to use separate

power sources (minimum 30 Amp each) for each

red power wire.

• BROWN WIRE - Second ignition output;

connect to the wire that switches +12V and

does not drop out during cranking.

• YELLOW WIRE - Main ignition output;

connect to the main ignition wire that switches

+12 V and does not drop out during cranking.

• ORANGE WIRE - Main accessory output;

This provides +12V output to heater and/or air

conditioning system. Some cars may have more

than one accessory wire. In these vehicles add a

relay(s) to power the extra accessory wire(s).

• PURPLE WIRE - Starter output; connect to

the vehicle’s starter wire.

1 2 3 4 5 6 7 ... 11 12

Komentarze do niniejszej Instrukcji

Brak uwag