Black Widow Security BW FM 250 Instrukcja Instalacji Pobierz pdf (Strona 6)

connector to the module and plug into

the red two pin connector. Push the LED

into the hole, it should fit snugly.

6. Install the Valet/

Override Switch:

Mount the valet/override switch in a hid-

den location, but that can still be found

by the customer for programming and

emergency override situations.

Run the 2 pin connector and wire har-

ness to the module and plug into the

matching blue two pin connector on the

module.

7. Connect the Illuminated

Entry Output:

Connect the Green/Black wire on the 3

pin accessory output plug to a SPDT relay

(See illuminated entry diagram).

Warning: don‘t connect the green/Black

wire directly to a door trigger wire, this

output is only designed to be used with

an outboard relay.

8. Connect Armed Output:

Orange wire on main harness

(see diagram)

This wire provides a 250ma ouput (-)

when the system is armed. See diagram.

Must use relay when connecting the

Orange wire.

9. Connect 2nd channel out-

put: Gray wire on main harness

This output is 500ma, and drives a relay

to open the electric trunk or hatch

release. (See diagram section).

NOTE: This output will work with the

ignition on or off. Press button#2 and

hold for 3 seconds.You will receive out-

put on the gray wire as long as you hold

button #2.

10. Connect Negative door

input: Green wire on main har-

ness

Connect the green wire from the module

to the wire that shows ground when all

of the doors are opened.Verify with

volt/ohm meter. Make sure that all doors

when opened separately make the target

wire provide a ground output.

11. Connect Hood/ Trunk

switch input:Blue wire on main

harness

Connect the blue wire to either or both

hood and trunk switches.They must pro-

vide a ground output when the trunk or

hood are opened.

12. Connect Positive door

input: Violet wire on main har-

ness

Connect the violet wire from the module

to the wire that shows 12v+ when all of

6

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Komentarze do niniejszej Instrukcji

Brak uwag